Issue: How to fix Windows 0xC0000221: STATUS_IMAGE_CHECKSUM_MISMATCH error?
I tried performing several system recoveries but to no avail. Now I‘m stuck with the BSOD screen. Tried running Windows Automatic Repaid. It stops in the middle and shows the message saying that “0xC000022: STATUS_IMAGE_CHECKSUM_MISMATCH” error appeared. Any suggestions to regain access to my PC?
Windows 0xC0000221: STATUS_IMAGE_CHECKSUM_MISMATCH error might appear due to a fatal error in a driver or in a system file. Alternatively, the reason behind this phenomenon may lay in the mismatch of system file header checksum with the supposed checksum value. As a result, your computer crashes and you encounter BSOD (blue screen of death) screen. Moreover, mechanic damages in hardware might be at fault. You should not exclude the probability that the system crash was triggered by the infected page or file. There are a couple of solutions for this problem. Firstly, you may check your system for corrupted registry keys and repair them with RegCure Pro.
Option 1. Choosing Emergency Repair Disk option
This method should work when no other options work – troubleshooting, Automatic Windows Repair, etc. How to create Emergency Repaid disk and use, check other resources. In this article, we will mainly focus on removing this error. Keep in mind that this feature does not replace regular backups. So when you regain full control of the computer, regularly back up your valuable documents.
Option 2. Checking for disk errors
Disk errors might be either caused by corrupted software or damaged hardware.
- Remove the hard disk from the current computer and insert them in another device.
- Navigate to Safe Mode with Command Prompt.
- Type Chkdsk /f /r. Reboot the system to start the scan process.
Option 3. Checking ROM compatibility
If the error occurred after the renewal of ROM, try placing it in another device. You might also run through these steps. They are applicable in Windows 2000.
- Set the default RAM settings.
- Launch Recovery Console to get to the partition where the paging file is.
- Delete pagefile.sys file.
- While Recovery Console is till open, run Chkdsk /r on the partition with the paging file.
- Reboot the system.
- Set the paging file to an optimal level depending on RAM added size.
- Turn off the system and add the new RAM.
Repair your Errors automatically
ugetfix.com team is trying to do its best to help users find the best solutions for eliminating their errors. If you don't want to struggle with manual repair techniques, please use the automatic software. All recommended products have been tested and approved by our professionals. Tools that you can use to fix your error are listed bellow: